网站标志
会员登录
module file (../../member/module/LoginForm.php) not exist
 
 
点评详情
发布于:2017-3-27 15:13:01  访问:1587 次 回复:0 篇
版主管理 | 推荐 | 删除 | 删除并扣分
Four Enticing Ways To Improve Your Fire Place Skills
Goodman Restore & Service In Oklahoma Metropolis
Furnace flame ignites until blower begins and goes off in 10 seconds 15 seconds and will ignite again and will repeat all evening long or till thermostat reaches temp.. System doesn`t lock out. Please click on here fire place (why not try this out) for our Furnace Management Boards Page In case your furnace lights and the fuel stays on for 8 to 10 seconds, then shuts proper back off, then that you must clear your flame sensor with light sand paper or steel wool. You need to be getting between 24 to twenty-eight volts from every terminal to floor if the stress change is closed. The vibration of the furnace over time sometimes wears through the wires insulation and causes a brief to floor. A. If the stress swap is open (power cannot cross by), the IFC starts the inducer. Please see limits, rollout switches & furnace control boards" further down on this page.
She texted me a short while ago before leaving for work and stated the furnace seems to be operating usually since she could not hear the induction blower biking on and off like yesterday morning and there was constant warm air coming from the air ducts. After a slight delay the fuel valve will open if the flame rollout swithches are closed.
If there`s a break down within the pressure swap or different restrict safety controls the furnace, on your safety, will not proceed with the ignition sequence. In case you have an open limit management both the furnace has over heated or the restrict has gone bad. Above are pictures of a draft inducers exhibiting where the strain swap tube attaches.
Beneath I`ve the crimson probe touching the highest terminal of the rollout switch and the black probe touching a floor (body) of the furnace. I actually don`t know if the furnace was working at that point, it wasn`t cold enough to need it however each few days at the moment. One factor the Bryant handbook says very clearly is that the trap have to be primed, and it must be executed by pouring a quart of water through the inducer and on out through the lure. Examine the stress change hose of your furnace for blocks or an improper connection.
Translate four LED flashes to imply your furnace has a primary limit circuit open, presumably from unfastened wiring or blocked filters. If you do not visually see a crack, then you would have a furnace management board drawback or a limit, rollout change downside. A. If any of the restrict switches are open, the furnace will lockout, the circulating fan will come on and a lockout code will likely be displayed. A very powerful sensor is the one on prime depending on how the furnace is put in.
共0篇回复 每页10篇 页次:1/1
共0篇回复 每页10篇 页次:1/1
我要回复
回复内容
验 证 码
看不清?更换一张
匿名发表 
脚注信息

海南省屯昌兴邦农业发展有限公司 Copyright(C)2013-2016